SmokingSanta wrote I'll give the XBOX a hard reset as well as the router.

Right, I've done what I said I would do. Still got a STRICT NAT on AW and now I have a STRICT NAT on the XBOX Network Settings. I've done Port Forwarding before hand. I have also manually setup my network instead of having it setup automatically.

So I don't know what else to do....

I Found this every Helpful [ Register or Signin to view external links. ]

HairyTarts wrote What I Done Is I Went Onto My Routers Ip Adress It Should Come Up With You Needing A User Name Which You Type In 'Admin' For The Username And For The Password There Should Be One Underneath Your Router, Type Tgem In And Look For Where It Says 'UPnP' If That Is Enabled Disable It. Now Go On Game And Application Sharing And Go To Configure Should Be On The Top Right Take Off Extended Security, Now Go To Set Game Mode And Make Sure That That Is Enabled That Is The Main Problem It Even Says 'This is a function that helps all games work through the NAT of your Technicolor Gateway.' Now Turn Of Your Router For 30 Seconds And Power Cycle Your Xbox One That Means Holding The Button Until The Adapter Goes Orange And There Is No Sound Don't Turn The Xbox On Until The Router Has Been Recovered Fully,This Is My Own Method And I Had A Open Nat On Xbox 360 But Never On The Xbox One And From Doing All These Steps It Made Call Of Duty Ghosts On Nat Open And Advanced Warfare Open And Even The Whole System Says Nat Type Open, If It Don't Work None Of This Is Lies And I'm Sorry If It Don't Work But Atleast Try My Method And If It Does Work Well Done And Add Me On Xbox: Pexsty

PEACE!

How long did it take you to use caps for only some of those letters?

This is how you would un restrict all ports

1. Go your routers ip Ex : 192.168.0.1 (Type that into the address bar)

2. Sign in. Usually the username and password will be : admin : admin: or admin : blank. In my case it is User : Admin | Password : Motorola.

3. Go to youtube and start listening to Blank Space by Taylor Swift.

4. Go back to the 192.168.0.1 tab and go to Firewall.

5. In Firewall go to "Basic".

6. In basic make sure your IPV4 Firewall setting is set to Low or Off. This will make sure NO ports are restricted from using your internet.

PLEASE KEEP IN MIND THAT YOUR ROUTERS GUI IS NOT GOING TO LOOK THE SAME AS MINE!!!!

Also!!! DON'T FORGET TO RESET YOUR ROUTER AFTERWARDS!!!!

[ Register or Signin to view external links. ]

Its either you have bad internet. Or if your using wifi to connect it, might be to far away or everyone is using it.