You are viewing our Forum Archives. To view or take place in current topics click here.
Nand wont read Making RGH Help
Posted:
Nand wont read Making RGH HelpPosted:
Status: Offline
Joined: Oct 31, 201013Year Member
Posts: 3,383
Reputation Power: 154
Status: Offline
Joined: Oct 31, 201013Year Member
Posts: 3,383
Reputation Power: 154
Shows this on Jrunner -
Version: 03
Flash Config: 0x00000000
Can not Continue
I Cant post pics at the moment but i will if you need. But the soldering is fine the board is clean. Also the trinity rgh yellow pad was burned but i done a solder retrace on that.
First time soldering them i used liquid flux what was pointless now i use flux paste.
-------------
Could it be that i have the Slim Proto Already Put on the Board and the QSB V3 on the board.
Also if its any help im also using Nand x RGH Edition
-----------
Im also using dads computer which is supremely protected against any software so should i try using a differnt computer because sometimes porgrams like Xbox Backup Creator and Imgburn dont work anymore even when i allowed them on the firewall.
Nand driver is also installed before asking and i have allowed File checks on Jrunner
PS Soldering cannot be bad because the xbox runs
Version: 03
Flash Config: 0x00000000
Can not Continue
I Cant post pics at the moment but i will if you need. But the soldering is fine the board is clean. Also the trinity rgh yellow pad was burned but i done a solder retrace on that.
First time soldering them i used liquid flux what was pointless now i use flux paste.
-------------
Could it be that i have the Slim Proto Already Put on the Board and the QSB V3 on the board.
Also if its any help im also using Nand x RGH Edition
-----------
Im also using dads computer which is supremely protected against any software so should i try using a differnt computer because sometimes porgrams like Xbox Backup Creator and Imgburn dont work anymore even when i allowed them on the firewall.
Nand driver is also installed before asking and i have allowed File checks on Jrunner
PS Soldering cannot be bad because the xbox runs
#2. Posted:
Status: Offline
Joined: Sep 10, 201310Year Member
Posts: 451
Reputation Power: 17
Status: Offline
Joined: Sep 10, 201310Year Member
Posts: 451
Reputation Power: 17
Is the PSU plugged into the console? make sure to not turn on the console, just plug in the PSU. That status usually means no power. Also why is this in the Xbox One Section?
- 0useful
- 0not useful
#3. Posted:
Status: Offline
Joined: Sep 10, 201310Year Member
Posts: 451
Reputation Power: 17
Status: Offline
Joined: Sep 10, 201310Year Member
Posts: 451
Reputation Power: 17
TX_F1ERCE_TX wrote Is the PSU plugged into the console? make sure to not turn on the console, just plug in the PSU. That status usually means no power. Also why is this in the Xbox One Section?Also I need to pics of your soldering.
- 0useful
- 0not useful
You are viewing our Forum Archives. To view or take place in current topics click here.