You are viewing our Forum Archives. To view or take place in current topics click here.
0022 on RGH1.0 jasper after updflash
Posted:

0022 on RGH1.0 jasper after updflashPosted:

Custom-Noble
  • New Member
Status: Offline
Joined: Sep 25, 201211Year Member
Posts: 36
Reputation Power: 1
Status: Offline
Joined: Sep 25, 201211Year Member
Posts: 36
Reputation Power: 1
I have a 16mb jasper I just tried RGH1.0 with (using CR rev c). I had everything perfect, instant boot into Xell, got CPU key, created xebuild image, flashed it with Xell, and then wouldn't boot. Eventually, all of a sudden the debug light stopped blinking. I looked to see if any wires came loose, they didn't. I changed some settings on the CR itself like the cap. Still wouldn't boot and no debug light. Reverted back to original NAND, after 5 seconds, 0022 error.

Any ideas what this might be?
#2. Posted:
Rodent
  • Winter 2022
Status: Offline
Joined: Jan 21, 201212Year Member
Posts: 10,040
Reputation Power: 12079
Status: Offline
Joined: Jan 21, 201212Year Member
Posts: 10,040
Reputation Power: 12079
possible bad flash . not too often do you see that error on jasper possible try reflashing it again make sure nothing is bridge near the nand x points or near hana chip
read more here
[ Register or Signin to view external links. ]
#3. Posted:
Custom-Noble
  • New Member
Status: Offline
Joined: Sep 25, 201211Year Member
Posts: 36
Reputation Power: 1
Status: Offline
Joined: Sep 25, 201211Year Member
Posts: 36
Reputation Power: 1
Rodent_Modz wrote possible bad flash . not too often do you see that error on jasper possible try reflashing it again make sure nothing is bridge near the nand x points or near hana chip
read more here
[ Register or Signin to view external links. ]


Tried reflashing multiple times both with Xell and directly through jrunner. Not that. Not anything with soldering either because I didn't touch anything from the point where it was working to the point where it wasn't working.
#4. Posted:
chrispro1994
  • Powerhouse
Status: Offline
Joined: Jan 03, 201113Year Member
Posts: 408
Reputation Power: 17
Status: Offline
Joined: Jan 03, 201113Year Member
Posts: 408
Reputation Power: 17
That's happened to me before I completely unsoldered everything and flashed back to retail and if it's still 0022 then there's a bridge somewhere. I've generally seen near pll_bypass or even the 3.3v will bridge to the wire next it, but I've only gotten 0010 from that.
Jump to:
You are viewing our Forum Archives. To view or take place in current topics click here.