well i dont think so the cheap method is the printer cable cost all of like $5$ to make but the downfall is it takes all day to read and write the nand. team xexcuter has the nand-x and i think its only 40 bucks and take 2 minutes to read and write the nand and its super easy on the xenon boards as long as you dont have any bad blocks.

thank you but 40 is to expensive for me. any other suggestions

lpt and nand-x is the only way ma i believe

matty014 wrote well i dont think so the cheap method is the printer cable cost all of like $5$ to make but the downfall is it takes all day to read and write the nand. team xexcuter has the nand-x and i think its only 40 bucks and take 2 minutes to read and write the nand and its super easy on the xenon boards as long as you dont have any bad blocks.

It takes like a hour to a hour and a half to read a nand on my lpt.And you can get a usb nand reader for like 20$.

use the LTP port method just a printer cable your computer and a few wires and diodes.

Depending where you are located Someone can do it for you if u were near NC I'd read and dump it 4 u.

TTG_iMatrix wrote Is there a cheap way to get usb nand reader/flasher (for example built it by yourself) or is there a good other method . Just want to built a xenon jtag not a rgh.

thanks
iMatrix

Just use Nand Flasher 360, put it on your usb and then transfer it over to XeX Menu then run the default.xex hers the DL
[ Register or Signin to view external links. ]

Theres a usb nand flasher for sale on [url=Xbox-experts.com]Xbox experts[/url] its only like 20 bcke i used to use one for awhile but it stopped working after about ten or so jtags, if u get it try wrapping it in electrical tape i think esd killed mine