Unplug anything plugged in, then plug in your HDMI cable and power brick.

Then, get your previous working updflash.bin and put it on a USB, then plug it on your RGH and click the eject button so you can boot up through XeLL.

After that, just let it update the nand, after that shut it down and pull off power brick for 30 seconds, then plug back in and boot it up.

You should be good to go.

thanks

when i boot to xell will it come up that it is flashing the nand or

DemiKid wrote thanks

when i boot to xell will it come up that it is flashing the nand or

yeah, it'll say found "updflash.bin" and then it'll do what it normally does and flash the nand into your RGH.

lent wrote

DemiKid wrote thanks

when i boot to xell will it come up that it is flashing the nand or

yeah, it'll say found "updflash.bin" and then it'll do what it normally does and flash the nand into your RGH.

it dosent say found how long does it normally take?

look at the end of this, somewehere in the end atlest..

DemiKid wrote

lent wrote

DemiKid wrote thanks

when i boot to xell will it come up that it is flashing the nand or

yeah, it'll say found "updflash.bin" and then it'll do what it normally does and flash the nand into your RGH.

it dosent say found how long does it normally take?

it keeps saying tring sda files then packet send error then no answer from server then keeps looping

it will show you how to put the updflash.bin in

giogio521 wrote look at the end of this, somewehere in the end atlest..

i cant get to that part as because of my bad nand flash it wont load to dashboard instead i get a redlight so i need to do it thru Xell

Do you have updflash.bin? if so, just look at the end of the video. If not, then i dont know.