Try booting safe mode WITH cmd prompt and run the windows recovery tool to reset to a earlier date.

KERNAL_DATA_INPAGE_ERROR -

"This Stop message indicates that the requested page of kernel data from the paging file could not be read into memory. This Stop message is usually caused by a bad block (sector) in a paging file, a virus, a disk controller error, or failing RAM. In rare cases, it is caused when nonpaged pool resources run out. It is also caused by defective hardware."

A. Make sure you have the RAM correctly seated and make sure that the RAM sticks are correctly working

B. If that doesn't work make sure to run a Hard drive test to make sure all the sectors in the hard drive are working correctly

How to do so -

1) Open Computer by clicking the Start button Picture of the Start button, and then clicking Computer.

2) Right-click the hard disk drive that you want to check, and then click Properties.

3) Click the Tools tab, and then, under Error-checking, click Check Now. Administrator permission required If you are prompted for an administrator password or confirmation, type the password or provide confirmation.

To automatically repair problems with files and folders that the scan detects, select Automatically fix file system errors. Otherwise, the disk check will simply report problems but not fix them.

To perform a thorough disk check, select Scan for and attempt recovery of bad sectors. This scan attempts to find and repair physical errors on the hard disk itself, and it can take much longer to complete.

To check for both file errors and physical errors, select both Automatically fix file system errors and Scan for and attempt recovery of bad sectors.

4) Click Start.

C) Re-Install windows if all fails.

---

CRITICAL_SERVICE_FAILED-

1. Reboot the system in safe mode by tapping F8 while holding the shift key. It doesn't work every time, but it does work a significant percent of the time. From there click Troubleshoot > Advanced Options > Windows Startup Settings > Automatic Repair.

2. You can also try System Restore if you have a restore point from this same place once you reach the Advanced Options menu.

3. If Automatic Repair does not work first. If those don't work: Go to the same place using the F8 Key + Shift and click on Command Prompt. Then use the bootrec commands to fix your computer. Using the command prompt you bring up (outside Windows) by clicking on Command Prompt at the Advanced Options"Blue Box of Choices", type these commands, hitting enter after each one. The order you use them doesn't matter, nor does upper or lower case in the commands. They work often when other Startup Repair mechanisms haven't in Win 7 and Vista, and I assume in Win 8.
bootrec /fixmbr
bootrec /rebuildbcd
bootrec /fixboot
bootrec /scanos

4. You can try putting in the Win 8 DVD .iso you burned and see if that will give you an option for repair. Often getting to Bios setup and putting the DVD first in the boot order and then starting from it (you'll get a "press any key to boot from CD/DVD" will get you a choice of repairing or selecting a drive to install it on.

5. Install Win 8 onto a USB flash drive as suggested above and try to run the recovery from there:
When you get into Windows from the flash drive, right click on the lower left corner of the desktop>select control panel from the context menu that pops up>Recovery will take you to the Win 8 version of the Advanced Options Menu.

6. You can enter the advanced settings by pressing escape just before the loading screen with fish is displayed! From there you can enter safe mode through the advanced setting.