Get the secondary error to help someone assist you.

How to find your secondary error code


Just count the lights that appear, there will be four digits to the code and remember, 4 lights= 0. (so an example would be E0102)

This is my error code

0021


but im gonna put a post of my heat sink...some people say cold solder and some say dvd i will post a pic up

1)If you worked on the mainboard recently(soldered or so) remove these wires because you might be drawing too much power from the Southbridge
Also look for missing/bridged components like capacitors/resistors
2) X-Clamp replacement
3) Southbridge X-Clamp-Fix
4) Reflow the Southbridge/Ethernet chip area
5) Reball the Southbridge - bridged solder
6) if you work in dumping lite-on 8xxxx and 9xxxx with jumper, Check your dvd drive pcb (board) again, if there's still some shorting.
7) Wrong GPU model (e.g. Zephyr/Falcon GPU reballed onto a Xenon board).

This error is caused by a bridged solder joint under GPU or Southbridge. It can also be power related(the Southbridge isnt getting enough power). Can also be a component that is missing or damaged so look for missing and bridged parts(caps etc) near the Southbridge

southbridge is the chip by j2d2 right

here is the south bridge
[ Register or Signin to view external links. ]

Does this look like a jasper to you???...


[ Register or Signin to view external links. ]

only reason im asking because it looks exactly like my xexon board????

[ Register or Signin to view external links. ]




look at this i dont work a lot with jaspers so just look at this but that does look just like a xenon just look at the power input

i know mine is an xexon but i couldnt tell because about the ebay one...i dont feel like fixing my rrod xexon and was gonna just buy one of these.....i wont be able to use my hard drive anymore right????

what do you mean if you have a xenon and buy a jasper then you can use a hdd from any phat xbox ( xenon falcon jasper)