Hey guys!

I'm currently trying to fix an Xbox that has a 1 red ring and a secondary of 1022! before i had that error it had the three red rind which i did do the X-clamp Fix and now it reads me the 1022! after looking up the error...

Known fixes:

1)If you soldered anything to the mainboard before it occured, whatever you are powering from this point is drawing too much power so get rid of it.Also get rid of everything that you can see that might bridge anything near the GPU.
2) X-Clamp replacement Hybrid - Tighten the GPU screws facing the HANA chip slightly more and make sure to be using a shim. Adding an extra shim on each side of the smaller chip dye will help to create more surface against the heatsink and will increase the chances of the error going away for good.
3) If there is a lot of flexing under the GPU, bake the board to unflex it
4) Reflowing GPU and HANA chip

Source...

[ Register or Signin to view external links. ]

Now i haven't did any soldering to the Xbox so it shouldn't be number 1!

I did try tightening the screws under the GPU and even added a nylon washer, but error still occurs!

Any Suggestions?