you need a coolrunner rev c or another mod chip to perform the rgh hack, you program the mod chip that will be permenantly in the xbox with xsvf file.

you want to take your nanddump and create a ecc file (with cr4 files checked) write that to mother board, then wire the chip to the board.

after your wired up and switched to phat (rgh 1.2 can only be performed on phats) boot then you should boot into xell.

might need to use a different timing file.

thanks for sharing your wealth off knowledge, i have it all wired up on both consoles cr revC and jrprogrammer. wiring was done buy an electronics repair man, so be 100%
thought i could follow the tut but something is a miss cr just has red light im getting wrong version when i try to write ecc??

Streamah wrote you need a coolrunner rev c or another mod chip to perform the rgh hack, you program the mod chip that will be permenantly in the xbox with xsvf file.

you want to take your nanddump and create a ecc file (with cr4 files checked) write that to mother board, then wire the chip to the board.

after your wired up and switched to phat (rgh 1.2 can only be performed on phats) boot then you should boot into xell.

might need to use a different timing file.

You do not need to have to check CR4.
Unless your using a CR4XL

Rodent_Modz wrote

Streamah wrote you need a coolrunner rev c or another mod chip to perform the rgh hack, you program the mod chip that will be permenantly in the xbox with xsvf file.

you want to take your nanddump and create a ecc file (with cr4 files checked) write that to mother board, then wire the chip to the board.

after your wired up and switched to phat (rgh 1.2 can only be performed on phats) boot then you should boot into xell.

might need to use a different timing file.

You do not need to have to check CR4.
Unless your using a CR4XL

Gives better results

Streamah wrote

Rodent_Modz wrote

Streamah wrote you need a coolrunner rev c or another mod chip to perform the rgh hack, you program the mod chip that will be permenantly in the xbox with xsvf file.

you want to take your nanddump and create a ecc file (with cr4 files checked) write that to mother board, then wire the chip to the board.

after your wired up and switched to phat (rgh 1.2 can only be performed on phats) boot then you should boot into xell.

might need to use a different timing file.

You do not need to have to check CR4.
Unless your using a CR4XL

Gives better results

.

Has nothing to do with better results. The witing for a CR4 is different then rgh 1.2. So does nothing for it by clicking CR4