u need to write the original nand dump back to.Thats why its not booting

I flashed a retail nand with simple nand flasher while i was on the console it said it had written and then rebooted and i heard it glitching but now it doesnt glitch at all ?

danieljephcott wrote I flashed a retail nand with simple nand flasher while i was on the console it said it had written and then rebooted and i heard it glitching but now it doesnt glitch at all ?

the og NAND? That's key. Why would you want to switch it back to retail tho?

I wanted the console normal again but now it wont even boot just makes the noises ?

If you are certain you successfully wrote the retail nand back to the console, be sure that the switch on the coolrunner is in the PRG position and the console should boot normally.

*In the PRG position there should be no light on the coolrunner at all when the console is plugged in and powered on. No red power light and no blinking green debug light.


If you've done that and the console still isnt' booting I'd try switching the coolrunner chip back and and press eject to attempt to boot Xell - maybe you didn't successfully reflash your stock nand after all.

danieljephcott wrote I wanted the console normal again but now it wont even boot just makes the noises ?

The noises? Man, I feel like I'm in a community with a bunch of 6th graders... Sketch, get yo forums back up, can't deal with this B.M. anymore..

Why would you wanna do that!??!!?

Insure that you flashed your original nand dump back. If you flashed it back using a nandx/jrp check your soldering and make sure nothing has gotten bridged...

I flashed it while i was on the console via simple nand flasher but now it just wont turn on it makes the sound of when you try to turn it on but it just doesnt turn on, is this even fixable?