These are the JungleFlasher instructions for the half-tray open method, necessary to extract/flash using JungleFlasher.

Introduction

To obtain the key and other drive specific info from LiteOn drives the user must be familiar with the correct method to set Half Tray Open this is especially important when doing 83850C fwd drives as the drive must be set into this position twice during the extract!

Using xbox360 to power the drive

If using a 360 to power the drive this method can be tricky to accomplish.
You need to power on the drive with Eject status closed but Tray Half Open To do this using an Xbox 360 as Power source, eject the DVD drive, then, press eject to close the tray.
Now this is the important part you MUST remove the DVD power plug (the black cable with white plug on back of DVD-ROM) from the DVD Drive BEFORE it closes fully.

Wait for a few seconds and replace the power plug into the DVD drive taking extreme caution to plug the plug the right way around once done, the drive is now powered, console thinks its closed but it is in fact half open.

Using a Connectivity Kit / Xtractor / power dongle to power the drive

For this method, we still need to power on the drive with the half open tray.
You need to power on the drive with Eject status closed but Tray Half Open To do this using a connectivity kit/power unit/Xtractor as Power source, eject the DVD drive, then, press eject to close the tray. Now this is the important part you MUST switch off the kit BEFORE it closes fully.

Wait for a few seconds and switch the connect kit on again drive is now at half open tray-