i have a jr programmer v2 i want to use it to rgh 1.2 a jasper motherboard.
although, when i plug it into my computer all i get is a solid red light..
when i open j runner i get this....
Unable to check files.
when i go to write the firmware i get this text log..
Wednesday, October 10, 2018 8:50:20 PM
J-Runner v0.3 Beta (7) Started
Unable to check files
Device Not Found
who can help me get this jr programmer out of bootloader?? ive reached out to jus about everyone that i could think of that could spread some light on this jasper motherboard "project"
and no luck.
uhmm for the wire that connects the jr programmer to the computer i have used a regular micro usb with a attatchment on the end that makes it fit into the jr programmer. would this be my issue or something far more severe??
P.s. please dont just link me to a youtube video because ive watched just about everyone of them regarding this issue, tried it all.
If you have a different usb cable I'd give a try just in case. Also disable any anti virus programs you have because I ran into a similar issue just recently even though I use it often with the same av protection.
Have you ever used this Jr programmer before with your current pc?
You should be able to reflash the jrp firmware as long as the switch is in the right position. Make sure both switches are away from the usb port, disconnect it from your console and plug it into your PC by itself and try reflashing it. You won't be able to do anything until you get it out of BL.
Yeah ikno. That's the problem im having, see the post above and read the log I put in.
When I connext my jr programmer alone with nothing attached I get a solid red light. When I go into j runner and try to re flash the firmware it doesnt acknowledge it being there... Therefore the text log in j runner says device not found as stated above !