AdviceNeed help with RGB/led SW
Posted:
AdviceNeed help with RGB/led SWPosted:
Status: Offline
Joined: Dec 29, 20185Year Member
Posts: 1
Reputation Power: 0
Status: Offline
Joined: Dec 29, 20185Year Member
Posts: 1
Reputation Power: 0
| Hi there I recently brought a while computer setup which I've run into two problem first is the RGB led switch is connected to a 2 pin connector which I can't find anywhere to put it on the mother board , all power is linked up but it seems as thou this should be placed with the HDD led and power led ect , I'm using a MSI x470 gaming motherboard with a Sahara pirate p15 case , which the case seems to be a hell of a problem and a half , does anyone know where I can put this two pin connector to be able to use the RGB button at the front of the case ? |
#2. Posted:
Status: Offline
Joined: Aug 13, 20149Year Member
Posts: 3,634
Reputation Power: 516
|
If you have an extra USB slot in the back that you aren't using, you could route the wire through the back and use a USB LED Light Strip Connector.
amazon.com/Connector-Solderless-C...&psc=1 Good luck bub |
- 0useful
- 0not useful
#3. Posted:
Status: Offline
Joined: Feb 07, 201014Year Member
Posts: 2,117
Reputation Power: 86
Status: Offline
Joined: Feb 07, 201014Year Member
Posts: 2,117
Reputation Power: 86
| It most likely will say in the CASE manual what IO or PWM or similar port it is to be plugged into . If possible posting a picture of the wires may help identify it |
- 0useful
- 0not useful
Users browsing this topic: None