Item description:

Verify flsh.hex file on a flash drive and in the far right USB slot!
4.82 flsh.hex MD5: 8E156C99101BF36EC3EDB832982AE46D
DO NOT USE ON CFW (Custom Firmware) (Only Supports OFW)
DO NOT USE ON PS3 Models 3xxx/4xxx (aka SuperSlims / Late Slim models) you will brick those console.
USE ONLY ON 4.82 OFW


PLEASE READ FIRST:
It's essential not to flood the browser memory with junk before running the exploit. The reason for this is that due to javascript core memory usage limitations we are scanning several times a small range of browser memory (a few Mb) to find some essential data in RAM, if the memory is flooded then the range to scan becomes much larger & the probabilities that our data is found in the smaller range decrease dramatically..
So in short, never use the browser or set a homepage you cancel before running the exploit!
If you need to, set the homepage to 'blank', close the browser then reopen it to start the flash writer.

v1.0.0 - Initial Release
Supports Direct OFW to CFW patching for All Phat and 2xxx Slim (minver 3.56 Dec 2010 and lower)
the NOR/NAND writer will just copy 3Mb of CoreOS data to both ros0 & ros1 in the flash memory.
There is only one version released for 4.82. The same hex patch file can be used on nor & nand.
It's as safe as possible, with a check for usb device & patch file making the exploit hang instead of corrupting flash if file is not found.
In case of corruption (extremely rare but could always happen), it's only a partial brick because no per console info ever gets erased so a hardware flasher could still be used if ever a recovery reboot was impossible.
​
Usage Tips:
1) Try using a LAN connection or a solid WiFi connection during exploitation. A weak signal can cause problems.
2) If the exploit takes more than 5 minutes to work, reload page, browser, or restart console and try again.
3) If you are using a LAN connection and experience network issues, make sure all cables to router are in working order.​

Steps:
1. Setup a small Web server on pc or smartphone. A custom miniweb application (from: [ Register or Signin to view external links. ] ) with small changes to the JaveScript, and supplied to host files if you would like to use it. Don't come to us for explanations about how to run a http server though. Google it.

2. Extract the files from release to your http server root folder.

3. Copy the "flsh.hex" file from release folder to root of flash drive.

4. Put a FAT32 USB key in port closest to BD Drive (/dev_usb000).

5. DOUBLE-CHECK your flash drive on XMB to make sure it shows up under Music, Photos, Videos, etc.

6. Open the PS3 browser File Address window, write the IP address of your server (and the port if not 80) & press the Start button.

7. Select the appropriate button for your console and wait for PS3 to power down. DO NOT STOP THE PROCESS ONCE STARTED!!

8. Once PS3 has powered down, reboot console and install CFW matching OFW version. If installing through XMB does not work, boot to recovery and install.​