You are viewing our Forum Archives. To view or take place in current topics click here.
Xenon reflow help
Posted:

Xenon reflow helpPosted:

iXixPerfXtionZx
  • Summer 2019
Status: Offline
Joined: May 05, 201013Year Member
Posts: 127
Reputation Power: 7
Status: Offline
Joined: May 05, 201013Year Member
Posts: 127
Reputation Power: 7
I was wondering if anyone could give many instructions or advice on how to reflow a xenon.
I have a heat gun and common sense im just looking for a little bit more details on how to do the project. thank you
#2. Posted:
5KMods
  • TTG Undisputed
Status: Offline
Joined: Jun 19, 201013Year Member
Posts: 5,070
Reputation Power: 216
Status: Offline
Joined: Jun 19, 201013Year Member
Posts: 5,070
Reputation Power: 216
probably more useful watching youtube videos.

Not more to tell you since your using a heatgun
#3. Posted:
iXixPerfXtionZx
  • Summer 2019
Status: Offline
Joined: May 05, 201013Year Member
Posts: 127
Reputation Power: 7
Status: Offline
Joined: May 05, 201013Year Member
Posts: 127
Reputation Power: 7
-Mafia5K- wrote probably more useful watching youtube videos.

Not more to tell you since your using a heatgun


what tools do you prefer
#4. Posted:
PodcastBandit_Fanboy
  • Rising Star
Status: Offline
Joined: May 20, 201112Year Member
Posts: 745
Reputation Power: 33
Status: Offline
Joined: May 20, 201112Year Member
Posts: 745
Reputation Power: 33
i have used a heat gun to reflow my xbox before. what i did was took some tinfoil and wrapped it over everything but the chip(s) i was reflowing. After i had done that i put the gun on the low setting held it 6-8 inches away from the board and made small circles NEVER STOPPING TO MOVE across everything i was reflowing. After about 5 minutes i put it on the high setting and did the same motions for about a minute. I let it sit for about 45minutes to an hour then i was done. It worked for me, maybe it will work for you!
#5. Posted:
Orca
  • Trusted Seller
Status: Offline
Joined: May 24, 201211Year Member
Posts: 8,589
Reputation Power: 10958
Motto: Need Dark Aether, Level 1000? PM | Da Tool User | Badge Hunter |
Motto: Need Dark Aether, Level 1000? PM | Da Tool User | Badge Hunter |
Status: Offline
Joined: May 24, 201211Year Member
Posts: 8,589
Reputation Power: 10958
Motto: Need Dark Aether, Level 1000? PM | Da Tool User | Badge Hunter |
Your damaging your console by heat gunning it the console might work but in the end your gun a have a rrod console again
#6. Posted:
JTAG-GALORE
  • TTG Addict
Status: Offline
Joined: Jul 27, 201013Year Member
Posts: 2,058
Reputation Power: 163
Status: Offline
Joined: Jul 27, 201013Year Member
Posts: 2,058
Reputation Power: 163
heatgun it at your own risk, it will more than likely damage the board permanently especially without a preheater -the board will warp

send in to a pro!
Jump to:
You are viewing our Forum Archives. To view or take place in current topics click here.